DIGITUS Power strip SMART PDU 0U, DIN49440 16A/250V power plug, 18x type E (NF-C61-314) sockets, 16A

Product number: DN-IP-V-2-18E

EAN: 5907772595701

Description

IPDU V power strip enables electrical energy measurement via a TCP/IP network. The front panel is equipped with 18 Type E sockets. It can be used in conjunction with an additional device (DN-S-BOX), allowing the connection of dedicated sensors for monitoring ambient temperature/humidity, dew point, door open/close status, as well as detecting the presence of water or smoke.

Technical details

Current: 16 A
Input Plug: IEC 60309 16A 1ph/N/PE 6h
Installation: Rack 0U
Metering: PDU Metering
Outlets: CEE 7/3
Phase: 1ph
Power: 3,6 kVA
Volts: 230 V

Downloads and Certificates

Datasheet

CE documents

DoC EU PL

Logistics

Customs tariff number: 85371098

Safety notes

This product is not intended for unsupervised use by children or persons under their care!
Prevent higher humidity or temperatures than those specified in the data sheet - Avoid moisture, dust or vapors, solvents, flammable gases.
Multiple sockets are not designed for permanent use with heavy loads!
Multiple sockets must not be cascaded (avoid stringing together several multiple sockets).
Defective multiple sockets must be taken out of service immediately and disposed of in an environmentally friendly manner.
In the event of a fault, take the product out of operation and contact a qualified electrician.
Do not open the product.
Disconnect the product from the power supply before cleaning. Do not use any aggressive or abrasive cleaning agents for cleaning.
The ingress of liquids can lead to a short circuit.