DIGITUS Power strip Monitoring and switching 1U, IEC320 C20 power inlet 16A/250V, 8x C13 outlets, 16A.

Product number: DN-DP-H-1-8C13

EAN: 5907772596845

Description

Power strip IPDU H enables switching on/off of outlets and power measurement via TCP/IP. The front panel is equipped with 8 IEC320 C13 outlets. Power ports are individually switchable through a network interface, SNMP, or directly using the button on the control panel. Integration with an additional device (DN-S-BOX) allows the connection of dedicated sensors to monitor: ambient temperature/humidity, door opening/closing, and detect the presence of water or smoke.

Technical details

Current: 16 A
Input Plug: IEC 60320 C20 inlet
Installation: Rack 1U
Metering: Outlet Metering
Outlets: IEC 60320 C13
Phase: 1ph
Power: 3,6 kVA
Volts: 230 V
Inch form factor (IEC 60297): 482.6 mm (19")

Downloads and Certificates

Datasheet

CE documents

DoC EU PL

Logistics

Customs tariff number: 85371098

Safety notes

This product is not intended for unsupervised use by children or persons under their care!
Prevent higher humidity or temperatures than those specified in the data sheet - Avoid moisture, dust or vapors, solvents, flammable gases.
Multiple sockets are not designed for permanent use with heavy loads!
Multiple sockets must not be cascaded (avoid stringing together several multiple sockets).
The maximum connected load must not be exceeded.
Defective multiple sockets must be taken out of service immediately and disposed of in an environmentally friendly manner.
In the event of a fault, take the product out of operation and contact a qualified electrician.
Do not open the product.
Disconnect the product from the power supply before cleaning. Do not use any aggressive or abrasive cleaning agents for cleaning.
The ingress of liquids can lead to a short circuit.